With the I.T. band issues I have been having I have been
doing a lot of research on recovery and prevention.
The main component of prevention is getting
the muscles that surround and connect to the I.T. band stronger.
Obviously there are many ways to accomplish
this, but the last thing I want to do is pay a ton of money for a gym
membership, so I started researching body weight exercises.
The more and more I read, the more I got
interested in overall strength.
I found
a site called Nerd Fitness that had a youtube video on a simple playground
workout for those that don’t have access to a gym while they were
traveling.
My town has a great
playground that was perfect for this, so I gave it a try, but the down side to
this is the overall timing with winter setting in.
As I continued to
research I found people creating workout equipment out of PVC pipe to allow
them to do the same moves I was doing at the playground. I came across this one that allowed for
everything I wanted to do, all in one self contained set up. I downloaded a couple of pictures from the
site and wrote down their materials list and went to work on recreating
it.
The site
recommended that for people below 180 pounds, the 1 ½ inch pipe was sufficient,
anyone over that should use 2 inch pipe to prevent the pipe from bowing and
possibly breaking.
Being that I am right
on the border I chose to go with the 2 inch, just to be safe.
The website suggested you measure from your
hip bone to the floor to get the proper height for the horizontal bars.
The width I figured out when I put
two folding chairs together and simulated a dip to see how wide would be
comfortable and measured the distance between. As far as the rest of the measurements I
simple made a guess on what I think would be enough to create a steady
platform.
For my set up I went with 3ft by 2.5ft for the base and 3ft tall for the parallel bars. After I finished all the
measurements I added up all the lengths I needed to give me a total length so I
new how much material I had to buy.
Here is what you will need:
28 - foot of PVC pipe (your measurements will determine how
much you need)
6 - T connectors
8 - 90 degree elbows
Hacksaw - to cut the sections you need
Sharpie - to mark your measurements
Masking Tape - this helps maintain a straight cut if you
don’t have a miter box
Glue - I used Gorilla brand expanding super glue, but there
is PVC specific glue available
(On a side note, the PVC pipe at Lowes was sold in 5ft and
10ft section. The 10ft section was only
a little more than a dollar more than the 5ft section, I am guessing because it
was pre-cut, so I would suggest going with the 10ft pieces and save some
money.)
I got started by measuring out one piece at a time and cut as I went.
I would dry fit each piece as I went making sure
everything was square. Once I finished
the base and it was all dry fit together I started on the uprights and parallel
bars. Since I didn’t have step by step
directions I took my time and would refer back to the pictures for guidance.
Once I was completely done, I gave it a
quick test run and worked perfectly. Now I just had to disassemble and glue it
up.
I glued it up just as I built it,
starting with the base; I would glue a couple of sections at a time to ensure
they stayed square until the glue set.
After
the base was finished I let it sit overnight to fully cure before I started the
uprights.
After it was all assembled and glued I let it sit over night to let the glue fully cure. Since then it has worked exactly as I hoped it would have. If I had to do it all over again I would highly recommend to spend a little extra and get the glue designed specifically for assembling PVC. I have already had to re-glue one section, but I think that is because I didn't get enough glue in the joint the first time. Anyway, this has been a fun project to work on and I am glad I did it.